Becsys5 Installation And Technical Manual

BECSys5 Installation and Technical Manual

The Definitive Guide to BECSys5: Comprehensive Installation and Technical Manual

2.2 Installing I/O Modules

The BECSys5 system uses a tiered backplane. Modules must be inserted from left to right, starting with the power supply module.

| Slot | Module Type | Model Example | Purpose | |------|-------------|----------------|---------| | 0 | Power Supply | BPS-500W | System power distribution | | 1 | CPU/Controller | BEC5-CPU-2 | Main batch logic processor | | 2 | Network Gateway | BEC5-NET-ETH | Industrial Ethernet (Profinet/EtherNet/IP) | | 3 | Analog Input | BEC5-AI-16 | 16 channels, 4-20 mA / 0-10V | | 4 | Digital Output | BEC5-DO-32 | 32 channels, 24 VDC sourcing | | 5 | RTD Input | BEC5-RTD-8 | 8 channels, PT100 3-wire | becsys5 installation and technical manual

Important: Never hot-swap modules while the chassis is powered. Always disconnect the main 24 VDC supply before removal. Temperature: 5°C to 45°C (41°F to 113°F) during

Chapter 3: Network Configuration and Addressing

1.3 Environmental Considerations

Temperature: 5°C to 45°C (41°F to 113°F) during operation
Humidity: 10% to 90% non-condensing
EMI/RFI: Keep at least 30 cm from high-power variable frequency drives (VFDs)
Grounding: Isolated earth ground for chassis (impedance < 1 ohm)

9.2 Factory Reset

To reset to factory defaults (preserves IP address? – No, resets to DHCP): Log in via web browser: https://&lt

Power off.
Press and hold physical "RESET" button (recessed) on MCM.
Power on while holding for 10 seconds.
Release after STATUS LED flashes orange.
Default credentials: admin / admin. License must be re-applied.

5.2 Application Software (BECSys5 Supervisor)

After BOS boots:

Log in via web browser: https://<controller-ip>:8443 (default admin/admin)
Accept EULA.
Upload license file (.lic from BEC).
Configure system parameters:
- Timezone, NTP server
- Site name & location
- Default unit preferences (metric/imperial)