Skip to content
Log In

K Two Teasing Tongues 5 Part B Install May 2026

While there is no official technical documentation for a product specifically named "K Two Teasing Tongues 5 Part B," the terminology suggests a component related to agricultural drawbar or hitch systems , likely for machinery manufactured by Ktwo Machinery

, a UK-based manufacturer of high-quality muck spreaders and trailers. Ktwo Machinery

Based on general heavy machinery installation standards and available Ktwo technical checklists, an "informative paper" on such an installation would typically cover the following technical areas: 1. Pre-Installation Inspection

Before mounting heavy drawbar components like a "tongue" or hitch assembly, operators must perform a Vehicle Checklist to ensure the host tractor and the trailer are compatible: Ktwo Machinery Torque Verification

: Wheel nuts must be checked after the first 10km of service or any part change. System Isolation

: Ensure hydraulic and air brake systems are not connected simultaneously, as they are separate systems. Compatibility k two teasing tongues 5 part b install

: Verify the coupling devices on both the tractor and trailer meet the required load ratings for the specific Ktwo model (e.g., Roadeo Contractor or Bio Muckspreader). Ktwo Machinery 2. Drawbar & Hitch Components (The "Part B" Assembly)

In Ktwo's product range, the "tongue" area often involves several optional or standard heavy-duty components: Sprung Drawbar

: A common upgrade for Ktwo trailers to improve ride quality and reduce stress on the tractor hitch. Manual or Hydraulic Jacks

: Used to support the tongue during the installation process. Fastener Requirements

: Standard assembly often requires Grade 8 or higher bolts, frequently using 10mm flat washers and lock nuts for secure mounting. Clarke Machinery 3. Installation Steps (General Procedure) While there is no official technical documentation for

While specific to the "Part B" kit, the general installation of a trailer tongue or drawbar assembly follows these stages:

: Use a hydraulic jack to align the trailer's "teasing tongues" (or drawbar arms) with the main chassis mounting points.

: Insert cap screws through the mounting brackets. Ensure two flat washers are used per bolt (one on each side) before securing with a lock nut. Brake Linkage

: If the part involves the braking system, install the switch cable or hydraulic lines. Safety regulations require that trailer brakes automatically activate if the coupling fails. Adjustment

: For units with slack adjusters, tighten the 19mm nut clockwise until tight, then slacken by half a turn to provide necessary shoe clearance. Ktwo Machinery 4. Safety and Maintenance Visibility Disconnect power before any wiring

: Ensure any new installation does not obstruct the dual LED light units or automatic covers. Professional Consultation

: Always consult the specific manufacturer's maintenance manual for your model's exact torque specs and part numbers. You can often find these by contacting Ktwo Machinery directly or visiting authorized dealers like Clarke Machinery Could you clarify if "Teasing Tongues"

is a specific nickname for a part on a certain machine, like a muck spreader beater silage trailer hitch Vehicle Checklist - Ktwo Machinery - UK

Error 2: "The unit vibrates but tongues don't flick"

Cause: You forgot the 15-degree clockwise twist. Fix: Detach. Reinstall using the Click & Twist method above. Do not try to run the motor without the twist; you will strip the internal plastic gears.

Step 1: Inspection

Examine Part B. You will see two small silicone tongues protruding from a oval base. Look at the underside of Part B. You should see a gold-plated pogo pin connector (4 small spring-loaded pins). Ensure these are clean and not bent.

Safety

  • Disconnect power before any wiring.
  • Use PPE: safety glasses, gloves.
  • Follow local electrical code for wiring and grounding.
  • If soldering, work in ventilated area.