Nalco Trac 115 Msds Updated -

This guide summarizes key safety information for Nalco TRAC115

, a corrosion inhibitor and tracking agent used in industrial water systems. 1. Critical Hazard Identification

TRAC115 is classified as a strong oxidizer and is toxic if swallowed. nalco trac 115 msds

Physical Hazards: Can generate heat, fires, or toxic vapors if it contacts strong acids or other incompatible materials. Health Hazards: Eyes: Causes serious irritation or damage. Skin: May cause burns or severe irritation. Inhalation: May irritate the nose, throat, and lungs. 2. Personal Protective Equipment (PPE)

Always use the following gear when handling this product to prevent exposure: Nalco Trac 115 Msds Free - This guide summarizes key safety information for Nalco

This is a formal Material Safety Data Sheet (MSDS) / Safety Data Sheet (SDS) report for NALCO TRAC 115, a fluorescent tracer dye commonly used in water treatment applications to detect leaks and measure system parameters.

Disclaimer: This information is compiled from standard industrial chemical SDS templates for fluorescent tracer dyes. NALCO TRAC 115 is generally a low-hazard product, but specific formulations may vary by region or batch. Always refer to the manufacturer’s most recent SDS provided with the shipment. This report does not constitute legal or professional safety advice. it may exhibit corrosivity (pH &gt

14. TRANSPORT INFORMATION

Special precautions: None. The product is safe for transport by road, rail, air, or sea in non-bulk quantities.

Section 8: Exposure Controls / Personal Protective Equipment (PPE)

This section defines the Occupational Exposure Limits (OELs) for any hazardous vapors or mists.

Engineering Controls: Eyewash stations and safety showers must be readily accessible in the immediate work area. Use local exhaust ventilation if mists are generated during mixing.
Respiratory Protection: Not normally required under normal handling. If TLV is exceeded (e.g., during a hot spill or steam cleaning), use an NIOSH-approved respirator with organic vapor/acid gas cartridges.
Hand Protection: Chemical-resistant nitrile rubber gloves (minimum thickness 0.4 mm). Neoprene or PVC are alternatives. Do not use natural latex.
Eye Protection: Chemical splash goggles (not just safety glasses) plus a face shield when transferring large volumes.
Skin/Body Protection: Long-sleeved chemical-resistant apron or coveralls. Rubber boots.

Practical safety tips (based on typical SDS content)

Wear appropriate PPE: chemical-resistant gloves, eye protection, and protective clothing; use respirators if recommended.
Use in well-ventilated areas or local exhaust to limit inhalation.
Store in original labeled containers, away from incompatible materials (acids, oxidizers) and heat sources.
Keep spill kits and neutralizing agents accessible; follow the SDS cleanup procedure.
For skin contact: flush with water and remove contaminated clothing; seek medical attention if irritation persists.
For large exposures or ingestion: follow SDS first-aid and contact poison control/medical personnel.

Section 13: Disposal Considerations

Waste Code: Not a listed hazardous waste under US EPA (40 CFR 261). However, it may exhibit corrosivity (pH > 12.5). Test pH before disposal.
Method: Neutralize (with dilute acetic acid or citric acid) and flush to a permitted wastewater treatment plant, or contract with a licensed chemical disposal service.
Container Disposal: Triple rinse or pressure rinse drums, then dispose of as non-hazardous scrap metal or plastic.