Prosecure Opti Combi Manual English [ EXCLUSIVE ]

Dorma ProSecure Opti Combi is a dual-technology sensor designed for automatic sliding doors, combining microwave motion detection with active infrared (AIR) safety zones.

Below is a detailed guide for installation, commissioning, and manual adjustment. 1. Installation & Mounting Mounting Height: Standard installation is usually between 2.1m and 3m

. Ensure the sensor is mounted securely above the center of the door passage. Preparation: Dorma Opti Combi Mounting Guide to mark and drill holes. Connect the cable to the door operator (e.g., Dorma ES 200 Brown/White: Power supply (12–24V AC/DC). Green/Yellow: Activation output (Microwave). Pink/Grey: Safety output (Infrared). 2. Commissioning (The "Learning" Phase)

Once powered on, the sensor enters an initialization phase where it "learns" its environment to avoid false triggers. Turn On Power: The status LED will alternate Stay out of the detection zone for approximately 25 seconds Completion: The LED will stop flashing. A indicates activation detection, while a indicates detection in the safety zone. 3. LCD Parameter Settings Opti Combi

features an LCD screen for precise manual adjustments. Use the pushbuttons to navigate the "C2" menu: Value Options Sensitivity 1 (High) to 5 (Minimal) Learning Time 1 (10s), 2 (30s), 3 (60s), 4 (180s), 5 (15m) Output Logic 1 (High), 2 (Low), 3/4 (Slave Modes) Signal Output 1 (On), 2 (Off - Maintenance Mode) 4. Mechanical Adjustments Sensing Area Angle: prosecure opti combi manual english

The sensing angle can be adjusted in steps of 7° (ranging from roughly 7.5° to 28.5°). Adjust the angle to ensure the infrared curtain covers the floor area directly in front of the door leaves. Width Adjustment:

Some modules allow for adjusting the width of the microwave field by rotating the microwave antenna or using internal shutters for the infrared zone. 5. Troubleshooting Tips Red/Green Flashing:

The sensor is still in the learning phase or has failed to initialize. Ensure no moving objects (like plants or fans) are in the field of view during setup. Door Won't Close:

Check if the output logic (C2-3) matches your door controller's requirements (Active High vs. Active Low). False Triggers: Dorma ProSecure Opti Combi is a dual-technology sensor

Lower the sensitivity (C2-1) or adjust the mounting angle to avoid detecting movement from cross-traffic. for a particular door operator model?

Assuming you mean the ProSecure Opti Combi boiler (English manual) — key useful features:

If you want, I can:

The dormakaba Prosecure Opti Combi is a combined microwave radar and active infrared sensor for automatic door activation and safety, meeting EN 16005 standards. It features an integrated LCD interface for programming and supports physical adjustments for mounting height and tilt angle. You can find the full technical details on the official dormakaba website. If you want, I can:

Disclaimer: Product designs, button layouts, and software versions may vary by region and manufacturing date. Always refer to the official printed manual included with your unit. This article is a comprehensive guide but does not replace the original safety instructions.

Section C: Manager vs. User Modes (Page 10-12)

The Opti Combi has a hierarchical access system:

Never lose the Manager Code. The manual explains that without it, you cannot disable the "Time Delay" function if someone has accidentally activated a 99-minute countdown.

3. Cephalometric Features (if equipped)

2. Product Overview

The Opti Combi typically features:

6.2. Periodic Maintenance