Tsk 3 Manual [top] - Taurus Energy Dispenser

Taurus Energy Dispenser TSK‑3 — Product Manual Report

How to Use the Taurus Energy Dispenser TSK 3 Daily

Here is a typical daily usage routine as outlined in the official manual:

1. Fill: Remove the carafe from the base. Fill with fresh water. Do not exceed 2 liters.
2. Replace: Set the carafe back on the base. Ensure no water drips onto the electronic contacts.
3. Select Mode: Tap the mode button to choose your desired program (Standard is default).
4. Start: Press the start button. The red light will illuminate.
5. Wait: The cycle runs automatically. The manual advises not to interrupt the cycle, as this may reduce the energetic effect.
6. Complete: When the light turns green (or the device emits a beep), the water is ready.
7. Consume: Pour directly into a glass. Do not reheat the energized water in a microwave, as this may neutralize the energetic structure according to the manual.

B. Common Problems & Solutions

| Problem | Probable Cause | Solution | | :--- | :--- | :--- | | No steam produced | Water tank empty. | Refill with distilled water. | | | Heating element broken. | Contact technical support for replacement. | | | Power cord unplugged/fuse blown. | Check power supply. | | Steam is spitting water | Limescale buildup. | Perform descaling procedure. | | | Water tank overfilled. | Reduce water level to MAX line. | | Water leaking from base | Tank cap seal is damaged/missing. | Check the rubber gasket on the cap; replace if cracked. | | | Tank is cracked. | Inspect tank for damage; replace tank. | | Burning smell | Dust on heating element. | Run the machine "dry" (with water but no client) briefly to burn off dust. | | | Electrical fault. | Stop use immediately and unplug. | taurus energy dispenser tsk 3 manual

A. Cleaning (Limescale Removal)

This is the most common maintenance requirement. Taurus Energy Dispenser TSK‑3 — Product Manual Report

• Frequency: Once a week in high-traffic salons; once a month otherwise.
• Method:
  1. Unplug and let the unit cool completely.
  2. Drain remaining water.
  3. Fill the tank with a mixture of water and white vinegar (ratio 1:1) or a commercial descaling solution.
  4. Let it sit for 30–60 minutes. Do not boil the solution unless the manual explicitly says to.
  5. Rinse thoroughly with clean water until the vinegar smell is gone.

3. Initial Setup

1. Remove all packaging.
2. Place on a flat, dry, heat-resistant surface (not near edges).
3. Clean the tank: rinse with warm water + mild soap, then rinse thoroughly.
4. First use – “flushing cycle”:
   • Fill tank with fresh water to MAX line.
   • Plug in → turn ON → set max temperature.
   • Dispense water until tank is empty. Discard water.
   • Repeat once. (Removes factory residues.)