.png)
V2000-c Rfid Access Control User Manual !free! › [SECURE]
V2000-C RFID Access Control User Manual
6.1 Anti-Passback (APB)
Prevents a user from swiping twice to let in a tailgater.
- Enable APB:
22 1 # - Logic: Once a card is used to enter, it cannot be used again until an exit reader or exit button is pressed (requires second reader or sensor on PUSH terminal).
- Disable APB:
22 0 #
4.3 Deleting Users
- Single Delete:
14 [User ID] # - Delete All Cards (Keep Master Code):
14000000 #(Use with extreme caution).
8. Maintenance Schedule
- Monthly: Clean card reading surface with dry microfiber cloth.
- Quarterly: Test emergency exit override function.
- Annually: Backup user list via management software (if RS485/Wiegand output exists). Replace backup battery (if equipped).
6.3 Blocking a Specific Card Without Deleting (Blacklist)
- Command:
26 [Card UID] # - Unblock:
27 [Card UID] #
Maintenance
- Clean reader surface with a soft, damp cloth; avoid solvents.
- Inspect wiring and terminal connections periodically.
- Backup configuration and logs before firmware updates.
- Replace any damaged seals or enclosures to maintain weather resistance.
Product Overview: V2000-C RFID Access Control Terminal
Classification: Standalone Access Control Terminal Primary Interface: Keypad & RFID Card Mounting: Wall-mounted (often used for outdoor or semi-outdoor environments due to rugged casing). V2000-c Rfid Access Control User Manual
Quick Troubleshooting Guide (From the Manual)
| Issue | Common Solution | | :--- | :--- | | "Invalid Card" | The card is not registered in the device, or the ID format is incorrect. | | Door won't open | Check power supply (ensure 12V is stable) or check relay wiring (NO vs NC settings). | | Forgot Admin PIN | Perform a hardware reset (usually involves shorting specific pins on the motherboard or pressing a reset button inside the casing). | | Cannot read cards | Clean the sensor area. If using ID cards, ensure the device supports 125kHz frequency. | V2000-C RFID Access Control User Manual 6