Long-press the Mode button (M) or toggle the power switch, usually located on the "trunk" or bottom of the car. Bluetooth Mode:
Switch to Bluetooth mode. Open your phone's Bluetooth, search for "WS-1958BT", and pair. It supports hands-free calling.
Switch to FM mode. Short-press the Play/Pause button to search for stations. Mode Switching:
Short-press the "M" button to toggle between Bluetooth, FM radio, TF card, and USB input. Volume/Track Control:
Long-press volume buttons to change volume; short-press to skip to the next or previous track. Selfie Mode:
Some versions support Bluetooth selfie, activated via button combination. 2. Charging and Battery
Connect the USB power cable (usually included) to a 5V charging source. LED Indicator: A charge indicator light typically turns on while charging. Play Time: Approximately 2–3 hours depending on volume. Battery Capacity: Built-in 18650 battery (often 1200mAh to 1800mAh). 3. Specifications Output Power: 3 Watts (6W total) or 2 Bluetooth Version: Frequency Range: 100-18KHz. Connectivity: Bluetooth, TF Card, USB Drive, AUX (audio line-in). Horn/Driver: 2 x 52mm Drivers (External Magnetic). 4. Troubleshooting Speaker does not turn on: Charge the device for at least 2 hours. Bluetooth not connecting:
Turn the speaker off and on again, ensure no other device is connected. FM radio reception is poor: Plug in the AUX/USB cable, as it acts as an antenna.
Note: This information is based on supplier datasheets for the EONKO/WSTER WS-1958BT Car Shape Speaker. WS-1958BT - Car MODEL SPEAKER
Introduction
Congratulations on purchasing the WS-1958BT music car speaker! This manual is designed to help you install, operate, and maintain your new speaker system. The WS-1958BT is a high-quality, Bluetooth-enabled speaker system designed to provide clear and powerful sound in your vehicle. ws-1958bt music car speaker manual
Features
Installation
Before installing the WS-1958BT speaker system, make sure to:
Speaker Installation
Subwoofer Installation
Operation
Troubleshooting
Maintenance
Warranty Information
The WS-1958BT music car speaker system comes with a limited warranty. For more information, please refer to the warranty card or contact our customer support team. Long-press the Mode button (M) or toggle the
Conclusion
The WS-1958BT is a portable, classic car-shaped Bluetooth speaker that combines a nostalgic aesthetic with modern audio features like FM radio, hands-free calling, and TF card support. 1. Key Specifications Audio Output: 2 x 3W stereo speakers (6W total). Battery: Built-in 1800mAh rechargeable 18650 battery. Frequency Response: 100Hz – 18kHz.
Bluetooth Version: 5.0 (supports music, calls, and remote selfie triggers).
Play Time: Approximately 2–3 hours depending on volume levels.
Charging: 5V input via USB (approx. 2–3 hours for full charge). Dimensions: Roughly 26.3 x 10.5 x 10.8 cm. 2. Controls and Ports
Most controls and ports are located in the "trunk" (rear) of the car model:
Ports: USB port (for U-disk playback), TF/microSD card slot, 3.5mm AUX input/headphone jack, and a Micro-USB charging port. Buttons:
Power/Mode (M): Long press to power on/off; short press to cycle through modes (Bluetooth, FM Radio, AUX, USB/TF).
Play/Pause: Short press to play or pause; also used for answering/ending phone calls.
Volume/Track (+ / -): Short press to skip tracks; long press to adjust volume. Bluetooth connectivity for wireless music streaming 2 x 6
Selfie Button: When in Bluetooth mode and paired with a phone, certain models allow triggering the camera shutter. 3. Operating Instructions Bluetooth Pairing WSTER Manuals & User Guides - Manuals+
Note: The WS-1958BT is a popular generic or OEM (Original Equipment Manufacturer) model, often associated with vintage-style car audio players or motorcycle audio systems. While specific button layouts may vary slightly depending on the brand affixed to the unit (such as Vtin, Pyle, or unbranded generics), the functionality described below covers the standard architecture of this device.
| Problem | Likely Solution | |---------|----------------| | No power | Check 12V outlet (try another device). Ensure cable is fully inserted. Check car fuse if outlet is dead. | | Cannot pair Bluetooth | Delete “WS-1958BT” from phone’s Bluetooth list, turn speaker off/on, and re-pair. | | Sound cuts out | Interference – move phone closer to speaker. Low battery (if portable). | | LED lights not working | Press the LED button multiple times. Some modes have lights off. | | FM radio poor reception | Extend the power cord fully – it acts as an antenna. Move to an area with clearer signal. | | Microphone not working | Ensure the speaker’s mic hole is not blocked. Check phone’s Bluetooth settings – enable “Phone audio.” |
Q: Can I use the WS-1958BT in my home?
A: Yes, but you need a 12V DC power adapter (like a universal laptop adapter) or a 110V-AC to 12V-DC converter with a cigarette lighter socket.
Q: How do I answer a call while listening to FM radio?
A: When a call comes in, the WS-1958BT automatically pauses the radio. Press the Phone (☎) button to answer. After hanging up, FM radio resumes.
Q: The remote control stopped working. What to do?
A: Replace the CR2025 battery. Ensure the IR sensor (a small dark bulb on the speaker face) is not covered by the mounting strap.
Q: Why does the speaker announce “The Hail” or “The device is connected”?
A: That is the built-in voice prompt. There is no way to disable it; it is a feature of this chipset.
Solution: Reformat the drive to FAT32 (not NTFS or exFAT). Limit folder depth to 2 levels. Ensure file names are under 32 characters. Max capacity: 32GB.
The primary function of the WS-1958BT is wireless streaming.